Targus pa610u ユーザーガイド
Windows CE Setup
Changing IP Addresses
33
If you have trouble making the LP-E Card synchronize with
the host, try removing the card and reinserting it or try
resetting your mobile computer. If you have to change any
IP addresses associated with the LP-E Card, use the
Network program from the Settings option of the Start
menu. This procedure is described in the next section.
Remember that you must remove and reinsert the LP-E
Card before any IP address changes will take effect. If you
have problems installing the card, refer to
the host, try removing the card and reinserting it or try
resetting your mobile computer. If you have to change any
IP addresses associated with the LP-E Card, use the
Network program from the Settings option of the Start
menu. This procedure is described in the next section.
Remember that you must remove and reinsert the LP-E
Card before any IP address changes will take effect. If you
have problems installing the card, refer to
Changing IP Addresses
Targus’ LP-E Card Applet allows you to view IP settings but
not to modify them. To modify any IP addresses used to set
up the LP-E, you must run the Windows CE Network applet.
not to modify them. To modify any IP addresses used to set
up the LP-E, you must run the Windows CE Network applet.
NOTE: Remember that, after you modify IP address settings,
you must remove and reinsert the LP-E Card before any IP
address changes will take effect.
you must remove and reinsert the LP-E Card before any IP
address changes will take effect.
On a Palm-size PC, you can run the Windows CE Network
applet by tapping Start/Settings/Network.
applet by tapping Start/Settings/Network.