Midland lxt114vp ユーザーガイド
LXT114 Series
OWNER'S MANUAL
www.midlandr
adio.com
GMRS/FRS Radio
Welcome t
o the w
orl
d of Midland electronics
Congratulations on your purchase of a high quality MIDLAND product. Y
our
2-way radio represents the st
ate-of-the-art in high-tech engineering.
Designed for GMRS (General Mobile Radio Service) operation, this
compact p
ackage is big in performance. It is a quality piece of electronic
equipment, skillfully constructed with the finest components.
The circuitry
is all solid-state and mounted on a rugged printed circuit board.
Your two-
way radio is designed for reliable and trouble-free performance for years to
come.
LCD DISPLA Y
1. TRANSMIT (TX) ICON
– Indicates
radio is transmitting a signal.
2. VOLUME METER– Indicates the
volume setting of the radio.
3. RECEIVE (RX) ICON
– Indicates
radio is receiving a transmission.
4.LOW BA
TTERY
ICON– Indicates the
battery level is low.
5. VOX ICON
– Indicates when VOX
mode is active.
6. CHANNELNUMBER
– Changes from
1~22 on GMRS/FRS band.
1
CONTROLS
7. PTT Button
– Press and hold to
transmit voice communication.
8. SCAN/LOCK Button
– Press to enter
SCAN mode. Press and hold to turn
KEYLOCK on/of
f.
9. UPs
and DOWN t
Button– Make
adjustments in MENU mode.
10. SPEAKER– Built-in speaker
.
11. ANTENNA
12. EXTERNALSPEAKER/MIC/CHG
.
JACK
13. POWER / MODE Button
– Press and
hold for at least 3 seconds to turn the
radio on/off. Press moment
arily to
access Menu mode.
14. MIC– Built-in microphone.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions : (1) this device does not cause harmful interference, and (2)
this radio must accept any interference that may cause undesired operation.
T o maint
ain compliance with FCC’s RF exposure guidelines, for body-worn operation,
this radio has been tested and meets the FCC RF exposure guidelines when used with
Midland Radio Corp. accessories supplied or designated for this product. Use of other
accessories may not ensure compliance with FCC RF exposure guidelines.
14
13
12
11
10
9
8
7
6
5
4
3
2
IMPORT
ANT NOTICE,
FCC LICENSE REQUIRED FOR GMRS OPERA
TION
(Only Applicable f
or GMRS
Radio Use in the United Stat
es)
The LXT114 Series operates on GMRS (General Mobile Radio Service)
frequencies which require an FCC (Federal Communications Commission)
license. Y
ou must be licensed prior to operating on channels 1 - 7 or 15 - 22,
which comprise the GMRS channels of the LXT114 Series. Serious penalties
could result for unlicensed use of GMRS channels, in violation of FCC rules,
as stipulated in the Communications Act's Sections 501 and 502 (amended).
You will be issued a call sign by the FCC which should be used for st
ation
identification when operating the radio on GMRS channels. Y
ou should also
cooperate by engaging in permissible transmissions only, avoiding channel
interference with other GMRS users, and being prudent with the length of their
transmission time.
T o obt
ain a license or ask questions about the license application, contact
the FCC at 1-888-CALLFCC or go to the FCC's website:
http://www.fcc.gov
and request form 605
.
Exposure To
Radio Frequency Energy
Your Midland radio is designed to comply with the following national and
international standards and guidelines regarding exposure of human being to
radio frequency electromagnetic energy:
- United States Federal Communications Commission, Code of Federal
Regulations: 47 CFR part 2 sub-p
art J
- American National S
tandards Institute (ANSI)/Institute of Electrical &
Electronic Engineers (IEEE) C95. 1-1992
- Institute of Electrical and Electronic Engineer (IEEE) C95. 1-1999 Edition
- National Council on Radiation Protection and Measurements (NCRP) of the
United States, Report 86, 1986
- International Commission on Non-lonizing Radiation Protection (ICNIRP)
1998
T o control your exposure and ensure compliance with the general population
or uncontrolled environment exposure limits, transmit no more than 50% of
the time. The radio generates measurable RF energy exposure only when
transmitting.
IMPORTANT
:Changes or modifications to this unit not expressly approved by
MIDLAND RADIO CORP .
could void your right to operate this unit. Y
our radio
is set up to transmit a regulated signal on an assigned frequency. It is against
the law to alter or adjust the settings inside the COMMUNICAT
OR to exceed
those limitations.
Any adjustment to your radio must be made by qualified
technicians.
M
MIIDD
L LAA
N
NDD
RR
A
ADD
I IOO
CC
O
ORR
P POO
R RAA
T TIIOO
N
N
5900 P
arr
etta Dr
ive
Kansas City,
MO 64120
Call 816.241.850
0
visit us at http://www
.midlandradio
.com
Note:
Feat
ures & Specifications ar
e subject to
chang
e without notice.
MIDLAND is not re
sponsible for unint
entional errors or omissions on its
pack
aging.
BA T
TERY INS
T ALLA
TION
Your LXT1
14 Series radio operates with 3 AAA
alkaline batteries or a NiMH
rechargeable batteries. The belt clip should be removed to ease inst
alla-
tion or removal of the batteries.
T o inst
all the batteries:
1. With the back of the radio facing you, remove the belt clip (see diagram
below) for easy access, then remove the Battery Cover by pressing
down on the top center and sliding it down from the radio.
2. Insert 3 AAA
batteries observing the polarity as shown on the Battery
Compartment. Inst
alling the batteries incorrectly will prevent the unit
from operating or may damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the belt
clip, making sure it locks into place.
BATTER
Y
COMPAR
TMENT
BATTER
Y
COMPAR
TMENT
COVER
Press her
e and
push down t
o open
BELT
CLIP
LOCK TA
B
BELT
CLIP
LATCH
CHARGING
THE BA T
TERY
Your LXT1
14 Series is equipped for using rechargeable NiMH batteries
which can be recharged by inserting the AC adapter into the radio charge
jack. Initial charge time is 24 hours. Charge time is about 12 hours
thereafter
. For maximum battery life, we recommend charging the
batteries when the low battery icon comes on. Remove the radios from the
charger when the charge time expires.
1. Only use our NiMH batteries.
2. Do not attempt to charge alkaline batteries or any batteries or
battery packs other than the one indicated in the manual.
This
may cause leakage and damage to the radio.
3. For long term storage of the radio, turn the radio OFF and
remove the batteries from the radio.
EXTERNAL SPEAKER/MICROPHONE J
ACK
T o use an optional speaker / microphone or headset:
lInsert the plug(s) into the
SPK/MICjacks
lPlace the earbud into your ear
, and adjust the mic into
your desired position.
!
SPK
MIC CHG
POWER ON/OFF
AND V
OLUME
Press the POWER/MODE
button for at least 3 seconds to turn the radio
on/off.
T o increase/decrease the volume level, press the
s\t
button
during RX
or ST
ANDBYmode. The
VOLUME METERwill indicate the
volume setting of the radio.
TRANSMITTING
AND RECEIVING A CALL
1. For maximum clarity, hold the radio 2 to 3 inches from your mouth.
2. Press and hold the PTT
button and speak in a normal voice into the
microphone. The
TXicon will appear continuously on the LCD Display
while transmitting.
3. T
o receive a call, release the
PTTbutton. The
RXicon will appear on
the display when your radio is receiving a transmission.
SCAN
Your radio can scan all 22 channels for activity
. T
o enter
, quickly press the
SCANbutton. Repeat the same procedure to exit.
Your radio will rapidly
scan each of the 22 channels and stop on any active channel for 4 seconds
before resuming scan. When you press the PTT
button to transmit on an
active channel, the scanning function will stop and remain on the active
channel. T
o resume scanning, quickly press the
SCAN button.
CALL ALER
T
Your LXT1
14 Series can transmit a call alert. T
o send, press the
PTT
button twice rapidly.
The TX
icon will appear while transmitting a call alert
and a tone can be heard on the speaker for confirmation.
KEYP AD L
OCK
Press the LOCK
button for 4 seconds. The “
Lo” icon will appear on the
display.
PTTwill still be active. Repeat the same procedure to unlock the
keypad, a “
LF” icon will appear on the display
.
CHANNEL SELECTION (GMRS/FR
S BAND)
Press the MODE
button once, and then the s
\t
buttons to select one of
the 22 GMRS/FRS channels. T
o confirm the selection, press the
PTT
button or press the MODE
button again to move to the next feature setting.
Note: T
o communicate between two LXT1
14 Series radios, all radios in
your group must be set to the same channel.
VO
X
To
turnVOX
on, press the
MODEbutton twice, the display shows “
VOX”
blinking while below the “oF
” icon appears. Select “on
” by pressing the
s\t
buttons and push the PTT
key or MODE
button again to confirm.
To
turnVOX
off, press the
MODEbutton twice, the display shows “
VOX”
blinking while below the “on
” icon appears. Select “oF
” by pressing the
s\t
buttons and push the PTT
key or MODE
button again to confirm.
OPERA TING
YOUR RADIO