Sony BDV-T58 ユーザーガイド

the
r O

erati

ons

Controlling Your TV with
the Supplied Remote

By adjusting the remote signal, you can control
your TV with the supplied remote.

• When you replace the batteries of the remote, the

code number may reset itself to the default (SONY)
setting. Reset the appropriate code number.

Press and hold TV "/1 while entering your
TV’s manufacturer’s code (see the table)
using the number buttons. Then release TV
"/1.

If the setting is unsuccessful, the currently
registered code is not changed. Re-enter the
code number.

Code numbers of controllable
TVs

If more than one code number is listed, try
entering them one at a time until you find the
code that works with your TV.

Changing the Brightness
of the Front Panel
Display

Press DIMMER.

Each time you press DIMMER, the brightness of
the front panel display is changed.

Saving Power in Standby
Mode

Check that the following settings are both made:

– [Control for HDMI] in [HDMI Settings] is set

– [Quick Start Mode] is set to [Off] (page 54).

Preparing the remote for
controlling the TV

Manufacturer

Code number

SONY

01 (default)

PANASONIC

SAMSUNG

02, 06

SHARP

TOSHIBA

VIZIO