U-Line 2275dwrrol インストール手順

www.U-LineService.com

11/2007

Full overlay drawer panels completely cover the drawer 
fronts and handles to give a built-in appearance. Overlay 
units are shipped ready for full overlay installation.

Note: For standard installations, both drawers mount the 
same and a 1/2" gap is achieved between drawers.

1. Cut the overlay to the following dimensions.

Full Overlay Dimensions:

Width:

23-3/4"

Height:

14-3/4"

The thickness of the wood overlay panel must be 3/4". 
The door panel must not weigh more than 20 lbs.

1. Open drawer. Pull drawer gasket out of groove (top 

edge of drawer only). Start in the middle and pull 
outward, moving toward the edge (see Figure 1). This 
may take some force. 

2. Remove and save the two screws located at the ends of 

the handle (see Figure 2). Remove the handle.

3. Remove existing panel and cardboard spacer. Discard 

the spacer.

1. If user-supplied cabinet handles will be used, attach 

their hardware to the overlay panel at this time.

User-supplied cabinet handles MUST be counter bored to 
make sure mounting hardware is below surface of overlay 
panel. Failure to do so can cause damage to overlay panel 
and/or drawer. Overlay panel will not sit flush to drawer if 
mounting hardware is not counter bored.

2. Place and tape the existing drawer panel on the back of 

the overlay panel (see Figure 3).

3. Drill the five holes (5/32" drill 3/8" deep) through both 

panels according to Figure 4. 

Gasket

Handle

Screw

Drawer Panel

Bottom of

Wood Panel

Back of

Wood

Panel

Side of

Wood Panel

Tape

11/32"

Bottom

3/8"

Both Sides

Top of

Wood Panel

14-3/4"

1"

11-7/8"

1"

23-3/4"

5/32" x 3/8" Deep –

5 Places

Vinyl Coated

Steel Panel

11-13/16"

1"

2-15/16"