Uniden dct756 ユーザーガイド

42

If you can make a local call by dialing only 7 digits instead of 10, you can program your local area code in your 
phone. If you get a call from within your area code, you will only see the 7-digit phone number. If you get a call from 
outside your area code, you will see all 10 digits. To enter an area code, follow the steps below:

Press [menu/clear]. Select the GLOBAL SETUP menu, and then the AREA CODE submenu.
Use the number keypad [0] to [9] to enter a 3-digit area code. If an area code has already been stored, it will 
appear in the display. Press [menu/clear] to delete the stored code, and then enter a new one.
Press

. A confi rmation tone sounds.

NOTE: Do not program an area code if you must dial all 10 digits to make a local call.

Using the DirectLink feature, a pair of handsets can function as two-way radios. You can 
have up to two pairs of handsets using DirectLink at a time. DirectLink communication does 
not interfere with the main base’s ability to make or receive telephone calls. You must set 
both handsets to use DirectLink communication to activate this feature. Other handsets can 
be used while two handsets are in DirectLink communication; however, the two handsets in 
DirectLink operation are not able to make or receive calls until DirectLink communication is 
canceled.

Press [menu/clear] and move the cursor to the DIRECTLINK MODE menu.
Press 

. The display shows TO ENTER DIRECTLINK MODE

PRESS SELECT.
Press 

. A confi rmation tone sounds, and DIRECTLINK MODE 

COMPLETE appears in the display.

1.
2.

3.

1.
2.

3.