Uniden exi3226 ユーザーガイド

www.uniden.com

Troubleshooting

If your phone is not performing to your expectations, please try these simple steps first. 

The charge/in use LED won’t
light when the handset is
placed on the base unit.

• Make sure the AC adapter is plugged into the base unit and wall outlet.

• Make sure the handset is properly seated on the base unit.

• Make sure the charging contacts on the handset and base unit are clean.
• Press channel during a call to help eliminate background noise.

• Make sure that the base unit antenna is in a vertical position.

• Move the handset and/or base unit to a different location away from metal

objects or appliances and try again.

• Make sure that you are not too far from the base.
• Check both ends of the base unit telephone line cord.

• Make sure the AC adapter is plugged into the base unit and wall outlet.

• Disconnect the AC adapter for a few minutes, then reconnect it.

• Change the digital security code (See page 45).

• Make sure line 1 or line 2 is pressed.
• The battery pack may be weak. Charge the handset on the base unit for 

more than 15 hours.

• The handset may be too far away from the base unit.

• Place the base unit away from appliances or metal objects.

• Change the digital security code (See page 45).
• Keep the handset away from microwave ovens, computers, remote control

toys, wireless microphones, alarm systems, intercoms, room monitors,
fluorescent lights, and electrical appliances.

• Move to another location or turn off the source of interference.

• The handset was picked up before the second ring.

• The call was placed through a switchboard.

• Call your local telephone company to verify your Caller ID service is current.

• Make sure that the CIDCW option is set to “

On

”.

The audio sounds weak 
and/or scratchy.

Can’t make or receive calls.

The handset doesn’t ring
or receive a page.

The Caller ID/CIDCW does
not display.

Severe noise interference.