Uniden tru448 ユーザーガイド
G E T T I N G S TA R T E D [ 15 ]
GETTING ST
ARTED
Mounting the Base Unit on a Wall
Setting the handset retainer clip for wall mounting
1) On the base unit, pull the handset retainer out of the
slot. Rotate it clockwise 180 degrees.
2) Flip the retainer from front to back. Slide it back into
the slot so that the lip of the retainer is up and the oval
is down. The retainer holds the handset in place.
is down. The retainer holds the handset in place.
Standard wall plate mounting
This phone can be mounted on any standard telephone wall plate.
1) Plug the AC adapter into the DC IN 9V jack. Route the AC
adapter cord inside the molded wiring channel as shown.
2) Plug the AC adapter into a standard 120V AC wall outlet.
3) Plug the short telephone line cord into the TEL LINE
jack. Route the cord inside the molded wiring channel
as shown.
as shown.
4) Plug the telephone line cord into the telephone outlet.
5) Raise the antenna to a vertical position.
6) Align the mounting slots on the base with the mounting
posts on the wall. Push in and down until the phone is
firmly seated.
firmly seated.
Do not use an
outlet controlled
by a wall switch.
outlet controlled
by a wall switch.
TRU448_OM 4/9/02 12:16 PM Page 15