EchoStar dsb-700 fta ユーザーズマニュアル
8
7
Program Satellite
Satellite 028.2
° E
LNB Type Type1
TP/Polar 11478/H
Symbol Rate 30000
Position
Step Move E W
Search type Auto Search
Start Search(Press OK)
2
3
4
Set
Signal Level
Signal Quality
6
52%
63%
? ASTRA2 ?
5
i
1
8
LNB Setting
LNB Freq.Low 5150
LNB Frq. High 5150
DiSEqC DiSEqC 1..4
DiSEqC Port 1
Polarity Control 13/18V
LNB Freq. Band Control 0/22kHz
LNB Type Index (1..8)
0/22kHz Control Off
LNB Power On
1
2
4
3
5
6
7
8
9
? Type 1 ?
i
A. Receiver and TV set-up
Check the
Installation
To get the most out of the EchoStar DSB-700 FTA it should be correctly installed, the dish should be
optimally aligned and the mechanical limit switches on the dish should be set properly. Press on the
remote control unit (RCU) or press /I on the front panel of the EchoStar DSB-700 FTA.
optimally aligned and the mechanical limit switches on the dish should be set properly. Press on the
remote control unit (RCU) or press /I on the front panel of the EchoStar DSB-700 FTA.
6. Operation and Menu Program
8
The receiver is supplied with factory setting and will start up with the
“Language Setting” menu. For more
information on the
“Language Setting” menu, please see page 9. Please follow the steps outlined below to
properly install the EchoStar DSB-700 FTA.
LNB Setting
Select the
“LNB Setting” menu in the “Installation”
menu using the keys.
Select the LNB type which conforms to your LNB usi
ng the keys.
Other parameter values should be changed
manually according to your LNB type.
Press the OK key to confirm your selection.
Select the LNB type which conforms to your LNB usi
ng the keys.
Other parameter values should be changed
manually according to your LNB type.
Press the OK key to confirm your selection.
Program Satellites
If you are unable to get any signal quality, please check the LNB Setting to ensure you have selected the corr
ect LNB and switch settings.
ect LNB and switch settings.
Refer to the Signal Quality bar and the Signal Lev
el bar at the bottom of the screen. It is recommend
ed that the signal is at the Medium level or higher.
If it is not , please adjust your satellite dish.
This menu is to align your dish to the selected sate
llite.
After setting the parameters, press the OK key to s
tore the parameter values and Start Search(Press O
K) to search the channels of the transponder you
want.
el bar at the bottom of the screen. It is recommend
ed that the signal is at the Medium level or higher.
If it is not , please adjust your satellite dish.
This menu is to align your dish to the selected sate
llite.
After setting the parameters, press the OK key to s
tore the parameter values and Start Search(Press O
K) to search the channels of the transponder you
want.