EchoStar dsb-880 2ci ユーザーズマニュアル
Section 1
User Manual
Page 1 - 2
Digital Satellite Receivers - Fixed
© 2
0
03 E
c
hoS
tar
Inte
Inte
rnati
o
nal
C
o
C
o
rp
orat
io
n
A
ll ri
g
h
ts
re
s
s
e
rv
ed
English
1
3.1. SINGLE FIXED DISH INSTALLATION
3.2. MULTIPLE LNB INSTALLATION
1. Connect the receiver to
the mains wall outlet.
2. On the rear panel, set
the ON/OFF switch to
ON.
ON.
3. Note that the receiver
initializes.
4. Wait for the initial start-
up to complete.
5. If your dish installation is
aimed at ASTRA1, live
video appears.
video appears.
6. If your dish installation is
aimed at another satellite,
a No signal message
appears.
a No signal message
appears.
7. Press the OK key.
8. Press the red key to
8. Press the red key to
choose Select SAT.
9. In the SAT list, select one of
the pre-programmed
satellites.
satellites.
10. Press the OK key twice.
11. If your dish installation is
11. If your dish installation is
correctly aimed, live video
appears.
appears.
12. If your satellite is not listed,
continue with the Guided
setup.
setup.
1. Make sure that the
LNB1 for ASTRA1 is
connected to the
DiSEqC switch port 1
and LNB2 for HOTBIRD
to port 2.
connected to the
DiSEqC switch port 1
and LNB2 for HOTBIRD
to port 2.
2. For the monoblock LNB,
please refer to the
manufacturer’s
specifications.
manufacturer’s
specifications.
3. Connect the receiver to
the mains wall outlet.
4. On the rear panel, set the
ON/OFF switch to ON.
5. Note that the receiver
initializes.
6. Wait for the initial start-up
to complete.
7. If your dish installation is
aimed correctly, live video
appears.
appears.
8. If your installation is
physically configured
differently, a No signal
message appears.
differently, a No signal
message appears.
9. Press the MENU key.
10. Select Installation - User
LNB and press the OK key.
11. For LNB1 select for Port: 2
and press OK.
12. For LNB2 select for Port: 1
and press OK.
13. Press the EXIT key.
14. If live video does not appear,
14. If live video does not appear,
continue with the Guided
setup.
setup.