Zon legacy elite special4 ユーザーガイド

G U I T A R S

G U I T A R S

Note: The “CAL” switch position #1 is for the highest string.

3. Hold the bass in the approximate playing position, and with a .050"

hex driver, rotate the optical adjustment hex screw (found on the top of

the Monolith structure) clockwise, until the alignment LED turns red.

Then turn it counterclockwise until the alignment LED turns green. This

will confirm you are in the correct adjustment range.

Note: If you do not achieve both colors lit, this does not necessarily

indicate a problem. It likely means that the string saddle height is at or

close to the very limit position.

4. Rotate the hex screw clockwise until the LED no longer shows green

(or counterclockwise until the LED no longer shows red), and continue

for approximately 1/8th turn. This should leave the hex screw set

between the red and green positions, with the LED not glowing.

5. Repeat above steps 2 and 3 for the remaining strings, one at a time.

6. When all the strings are calibrated, return the “CAL” switch position to

“0.” (The red/green alignment indicator LED cannot light in this position.)

Saddle height. With a large flat-blade screwdriver, rotate the saddle

slug in half-turn increments—clockwise for lower action, counterclock-

wise for higher, until the desired string action is achieved. (Each half-

turn raises or lowers the action by 1/32".) Align the rotations so the

string saddle channel is accurately parallel with the string path.

Preliminary Optical Alignment. Using a .050" hex driver, rotate the

Monolith’s optical adjustment hex screw clockwise for up and counter-

clockwise for down, until the Infrared light emitter LED is approximately

parallel with the string. This will assure that the string is in the approxi-

mate position for final zeroing of the optics.

Intonation. Proper string intonation is achieved by manually shifting

each complete monolith structure either towards the nut (for a flat pitch

reading at the 12th fret) or away from the nut (for a sharp pitch reading

at the 12th fret). This adjustment is made with the string loosened prior

to moving the Monolith structure.