Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
79
Configure Congestion Parameters
To configure Congestion Parameters, follow the steps below.
1
Type “3” on the Frame Relay Options menu to display the Fame Relay
Congestion Configuration menu (Figure 4.49).
Figure 4.49
Frame Relay Congestion Configuration Menu
2
Select Configure Transmit Congestion Parameters and then follow the on-
screen messages to
•
FECN/BECN condition set size
•
FECN/BECN condition clear size
•
FECN/BECN max number of bytes to store
− or −
Select Configure Receive Congestion Parameters and then follow the on-
screen messages to
Select Configure Receive Congestion Parameters and then follow the on-
screen messages to
•
FECN/BECN condition set size
•
FECN/BECN condition clear size
•
FECN/BECN max number of bytes to store
4
Reset the IAD for changes to take effect.
Enable/Disable CopperMountain CMCP
NOTICE:
When using a CopperMountain DSLAM, CMCP allows the DSLAM to
configure many IAD parameters automatically. IAD parameters
controlled by CMCP include fragmentation and voice gateway support.
For more information, refer the CopperMountain DSLAM guide.
configure many IAD parameters automatically. IAD parameters
controlled by CMCP include fragmentation and voice gateway support.
For more information, refer the CopperMountain DSLAM guide.
1
Type “4” on the Frame Relay Options menu. The IAD displays the CMCP
status and prompts you to change it.
2
Type “E” to enable CopperMountain CMCP or “D” to disable.
Router Configuration
This section describes how to configure the IAD as a router. You may
configure the IAD as a router or a bridge, depending on your application.
configure the IAD as a router or a bridge, depending on your application.