Zhone 2000 ユーザーガイド

ページ / 296
102
2 0 0 0 - A 2 - G B 2 3 - 0 0
Basic Voice Path Setup Tasks
To configure voice path settings, you should complete the following tasks:
Set a voice gateway (page 4-102)
Set the jitter delay (page 4-118)
Select country mode (page 4-123)
Select DuSlic mode (page 4-123)
Configure voice gateway options (page 4-102)
NOTICE: 
You must reset the IAD for configuration changes to take effect.
Voice Configuration Menu
Configuring the voice path settings involves several tasks. These are all 
displayed and accessed on the Voice Configuration menu, displayed by typing 
“P” on the Main menu. Remember always to reset the IAD when you have 
finished voice configuration for your changes to take effect.
Figure 4.62
Voice Configuration Menu 
NOTICE: 
You must sign on as Supervisor to configure voice path settings. Be sure 
to reset the IAD when you are done making changes to the voice path 
settings. Resetting the IAD causes the configuration changes to take 
effect.
Set Voice Gateway
To select a voice gateway, type “V” on the Voice Configuration menu. The 
IAD displays the Voice Gateway Selection menu, which contains a list of 
valid voice gateways for this IAD.
NOTICE: 
Figure 4.63 displays the list of valid gateways. Only the “s” versions 
support MGCP and SIP.