Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
105
2
Enter a zero (0) in each port location to disable the port; enter a 1 in each
port location to enable the port. Press Enter to complete the step. The IAD
displays the AAL2/LES Manual Configuration menu.
Set CAS Refreshing Rate
1
1
Type “R” on the AAL2/LES Manual Configuration menu to set the CAS
refresh rate.
2
Enter a zero (“0”) to disable CAS refresh, or enable CAS refresh by
entering a non-zero refresh rate value. The IAD displays the AAL2/LES
Manual Configuration menu.
3
Reset the IAD before enabling Idle CAS refresh.
Enable/Disable Idle CAS Refreshing
1
1
Type “I” on the AAL2/LES Manual Configuration menu to enable or
disable idle CAS refreshing. You can only enable idle CAS refresh when
CAS refresh is enabled (immediately preceding).
2
Type “E” to enable Idle CAS refresh, or D to disable Idle CAS refresh. The
IAD displays the AAL2/LES Manual Configuration menu, and indicates in
the message section that the change in the Idle CAS refresh will take place
when the IAD is reset.
Change Maximum CPS-SDU Size; 45/64 Octets
Type “S” on the AAL2/LES Manual Configuration menu to switch the
maximum CPS payload size between 45 and 64 octets. The IAD displays the
AAL2/LES Manual Configuration menu. Included in the settings is a payload
size message indicating 45 or 64 octets.
AAL2/LES Manual Configuration menu. Included in the settings is a payload
size message indicating 45 or 64 octets.
Set “Combine Use” Timer
1
1
Type “T” on the AAL2/LES Manual Configuration menu to modify the
combined use timer (in 5 ms increments).
2
Type the new timer period and press Enter. The IAD updates the setting and
displays the menu.
Enable/Disable User State Control
Type “U” on the AAL2/LES Manual Configuration menu to enable or disable
user state control by toggling the state. The IAD displays the AAL2/LES
Manual Configuration menu. Included in the settings is a USC message
indicating that it is enabled or disabled.
Manual Configuration menu. Included in the settings is a USC message
indicating that it is enabled or disabled.
Enable/Disable Dialed Digit
1
1
Type “E” on the AAL2/LES Manual Configuration menu to enable or
disable dialed digit by toggling the state. The IAD displays the AAL2/LES
Manual Configuration menu. Included in the settings is a message
indicating that dialed digit will be enabled or disabled after reset.