Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
113
2
Type the DNS name (mg1.acme.com, for example), or the IP address of the
call agent and press Enter. The IAD updates the IP address of the MGCP
Call Agent (which controls call setup and teardown for all call features
under MGCP) for the entity, increases the entity index by one and prompts
you to complete the entries for call agents or press Enter to leave the
agent(s) unconfigured.
3
The IAD next prompts you to enter the listening port. Enter the listening
port of the Notified Entity:
4
Type the port number (usually 2427 or 2727) that the call agent is listening
on, and press Enter. The IAD displays the available interfaces and prompts
you to select an interface from those available.
5
Type the option number to select the signaling interface for MGCP to use
(typically the WAN interface). The IAD displays the port table for this
interface and prompts you to enter a port.
6
Type the port to configure and press Enter. The IAD displays a bracketing
prompt.
7
Type “Y” to wrap the port in brackets for call agent API compatibility, or
“N”, and press Enter. The IAD prompts you for the outbound signaling
“N”, and press Enter. The IAD prompts you for the outbound signaling
packets TOS field value:
8
Type the field value and press Enter. The IAD prompts you for the RTP
transport packets TOS field value:
9
Type the field value and press Enter. The IAD saves the settings and
redisplays the MGCP/NCS Management menu so you may continue
configuring MGCP/NCS.
CODEC Selection
Menu
Type “E” on the MGCP Management menu to select the CODEC option you
wish to use. The default is G.729a. The use of 726 and 729a are mutually
exclusive; the IAD will configure only one or the other.
exclusive; the IAD will configure only one or the other.
Display MGCP
Statistics
Type “S” on the MGCP Management menu (Figure 4.79) to display the
endpoint (line) and connection statistics. If no calls are active, the IAD
indicates if the Endpoint is currently connected to its Notified Entity or not.
If MGCP configuration is not correct, the IAD displays a message warning
you that the configuration is invalid and initialization is incomplete.
indicates if the Endpoint is currently connected to its Notified Entity or not.
If MGCP configuration is not correct, the IAD displays a message warning
you that the configuration is invalid and initialization is incomplete.
Remove a Connection
1
Type “R” on the MGCP Management menu (Figure 4.79) to remove a lost
connection.
2
Type the number of the Connection ID to delete and press Enter.
Port Administration Type “A” on the MGCP Management menu to (Figure 4.79) to display the
Port Administration menu (Figure 4.80).