Zhone 2000 ユーザーガイド
114
2 0 0 0 - A 2 - G B 2 3 - 0 0
Figure 4.80
Port Administration Menu
NOTICE:
These options are only available when you log in at the Network
Administrator or Supervisor levels.
Administrator or Supervisor levels.
Set Admin State for All Ports
1
1
Type “1” on the Port Administration menu (Figure 4.80) to enable or
disable the admin state for all ports.
2
Type “E” to enable the admin state, or “D” to disable it. The IAD saves the
mode you’ve selected and redisplays the Port Administration menu.
3
Press Escape to return to the Voice Configuration menu and continue with
other voice path configuration.
Display Current Admin State
To display the Current Admin State, follow the steps below.
1
Type “2” on the Port Administration menu (Figure 4.80) to display the
current admin state by port number. The IAD displays the report:
2
Press any key to return to the Port Administration menu.
Configure Admin State per Port
To configure the Admin State per port, follow the steps below.
1
Type “3” on the Port Administration menu (Figure 4.80) to enable or
disable the admin state for a specific port. The IAD prompts you to enter a
port.
2
Type the port number to set. The IAD prompts you to enable or disable Port
Administration for that port.
3
Type “E” to enable the admin state, or “D” to disable it. The IAD saves the
mode you’ve selected and redisplays the Current Admin State menu.
4
Press Escape to return to the Port Administration menu and continue with
other voice path configuration.
Restart Endpoint
To restart an Endpoint, follow the steps below.
1
Type “4” on the Port Administration menu (Figure 4.80) to reset the
connection between the Voice Port phone and the MGCP voice gateway.
(Use this option if one side of the link incorrectly identifies a call as up and
the other side thinks the call as down.)