Zhone 2000 ユーザーガイド
130
2 0 0 0 - A 2 - G B 2 3 - 0 0
Configure DHCP Server Parameters
1
Type “I” on the DHCP Server Configuration menu, or continue from the
Checking Additional DHCP Servers section above. The IAD displays the
gateway address and prompts you to enter a new one.
2
Type the IP address of the gateway and press Enter. If there is no gateway
available, type the address of the Ethernet port. The IAD displays the
current DNS Server address and prompts you to enter a new DNS Server IP
address.
3
Type the new DNS Server address, or type 255.255.255.255 to use a
DNS Server assigned from another port. Press Enter to continue. The IAD
displays the current NetBIOS Server address and prompts you to enter a
new NetBIOS Server IP address.
4
Type the IP address of the new NetBIOS Server and press Enter. The IAD
displays the current Subnet Mask and prompts you to enter a new one.
5
Type the new subnet mask and press Enter. The IAD displays the current
Domain name and prompts you to enter a new one.
6
Type the new domain name and press Enter. The IAD displays the current
Lease Time and prompts you to enter a new DHCP Lease Time.
7
Type the new Lease Time value in seconds, and press Enter. The IAD
displays the NetBIOS Type Configuration menu.
8
Type the option for the NetBIOS node type, and press Enter.
9
Press Escape to return to the DHCP Server Configuration menu and
continue configuring DHCP Server.
Configure DHCP Address Range Pool
You must configure the DHCP address range pool to set the range of IP
addresses to return to the DHCP clients. All IP addresses must be on the same
subnet.
To configure the DHCP address range pool, follow the steps below:
addresses to return to the DHCP clients. All IP addresses must be on the same
subnet.
To configure the DHCP address range pool, follow the steps below:
1
Type “P” on the DHCP Server Configuration menu to select Configure
DHCP Address Range Pool. The IAD displays the current High IP address
and prompts you to enter a new one.
2
Type the new High IP address and press Enter. The IAD displays the current
Low IP address and prompts you to enter a new one.
3
Type the new Low IP address and press Enter. The IAD displays the DHCP
Server Configuration menu.
Configure DHCP Client Entry
You can configure up to 10 static DHCP client entries by following the steps
below.
below.