Zhone 2000 ユーザーガイド

2 0 0 0 - A 2 - G B 2 3 - 0 0

Verify the WAN link status:

•

SDSL Interface—the LINK indicator blinks while the IAD synchronizes with 

the DSLAM, and lights continuously when the link is established.

•

T1/E1 Interface—the LINK indicator blinks while the IAD synchronizes 

with the voice gateway, and lights continuously when the link is 

established. 

Connect a POTS telephone to a provisioned line port on the IAD.

Lift the telephone receiver and check for dial tone. If no dial tone is present, 

troubleshoot as necessary. (See Troubleshooting the IAD on page 7-201.)

Repeat steps 2 and 3 for each provisioned line port.

Disconnect the telephone once you are through testing the line ports.

Use a crossover cable to connect the PC to the Ethernet LAN port on the 

IAD. Determine that the PC is configured with an IP address on the same 

subnet as the IAD.

Observe that the LINK indicator on the IAD front panel lights to verify that 

the IAD is connected to the LAN.

Run Ping on the PC to ping a known good address on the IAD and verify the 

acknowledgement. If a timeout occurs, troubleshoot the LAN path to the 

IAD.

Ping a known good address on the network and wait for acknowledgement.
If a timeout occurs, troubleshoot the LAN path to the IAD.

Disconnect the Ethernet cable between the PC and the IAD.

Using a straight-through cable, connect the Ethernet LAN port on the IAD 

to your local LAN patch panel or hub|switch|router.

Connect the IAD telephone ports to the local distribution frame or patch 

panel.

The IAD is ready for service.

The IAD menu interface contains utilities reserved for factory maintenance 
and development. Before running any System Utilities, consult your technical 
support representative.

To display the current configuration and data transmission status, follow the 
steps below.

On the Main menu, type “1” to display the Reports menu.