Zhone 2000 ユーザーガイド
16
2 0 0 0 - A 2 - G B 2 3 - 0 0
NOTICE:
If you are entering the menu to change a previously established
configuration, refer to Managing Configuration Files on page 4-45 to
save the current configuration for fast restoration in case the new
configuration does not work.
configuration, refer to Managing Configuration Files on page 4-45 to
save the current configuration for fast restoration in case the new
configuration does not work.
Figure 2.2
Main Menu
NOTICE:
Options vary depending on the voice gateway selected in the Voice Path
Configure command. Refer to Voice Path Configuration on page 4-101.
Configure command. Refer to Voice Path Configuration on page 4-101.
NOTICE:
When the IAD prompts you for input, the current value is displayed in
parentheses. To conveniently accept the current value, just press Enter.
parentheses. To conveniently accept the current value, just press Enter.
Setting the Ethernet Port IP Address
Before you configure the Ethernet IP address, you should know the IP address
and subnet mask that are to be assigned to this port. They may be displayed
on the work order, or you may obtain or determine the appropriate IP address
by consulting with the network administrator.
The IAD is shipped with the IP address set to
and subnet mask that are to be assigned to this port. They may be displayed
on the work order, or you may obtain or determine the appropriate IP address
by consulting with the network administrator.
The IAD is shipped with the IP address set to
192.168.1.254
and the
subnet mask set to
255.255.255.0
. To configure a port IP address, follow
the steps below.
1
On the Main menu, type “2.” The IAD displays the Router Configuration