Zhone 2000 ユーザーガイド

To configure the System Name, follow the steps below.

Type “N” on the SNMP Configuration menu to configure the system name 

(up to 39 alphanumeric characters). The IAD displays the current system 

name and prompts you to enter a new one.

Type the new system name and press Enter. The IAD saves the 

configuration. 

Continue with other SNMP settings, or press Escape to return to the Main 

menu.

Reset the IAD.

To configure the System Location, follow the steps below.

Type “L” on the SNMP Configuration menu to configure the system 

location (up to 39 alphanumeric characters). The IAD displays the current 

system location and prompts you to enter a new one.

Type the name of the new server location and press Enter. The IAD saves 

the configuration. 

Continue with other SNMP settings, or press Escape to return to the Main 

menu.

Reset the IAD.

The value you set must match the write community name of the SNMP host 
to enable the SNMP Set operation. If you enable SNMP and the read-write 
Community Name is null, SNMP enters read-only mode with a community 
name of “public.”

Type “C” on the SNMP Configuration menu to select Configure System 

Location. The IAD displays the current community name and prompts you 

to enter a new one.

Type the name of the SNMP community to which your system belongs and 

press Enter. The IAD saves the configuration. 

Continue with other SNMP settings, or press Escape to return to the Main 

menu.

Reset the IAD.

To configure the SNMP Trap Host IP Address, follow the steps below.

Type “T” on the SNMP Configuration menu to select Select Configure 

SNMP Trap Host IP Address of the system setup for trap operations. The 

IAD displays the current IP address and prompts you to enter a new one.