Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
51
Toggle SDSL Mode
(CPE or CO)
To select CPE or CO Mode, follow the steps below.
1
Type “1” on the SDSL Configuration menu (Figure 4.8). The IAD displays
the current SDSL Mode and prompts you to change it.
2
Type “1” to select CO, or type “2” to select CPE. The IAD sets the mode
and redisplays the SDSL Configuration menu.
NOTICE:
The CO Mode is reserved for testing. CPE is the normal mode.
Set SDSL Speed to
Auto Cycle (Nokia)
To select Auto Cycle - Nokia DSLAM, type “2” on the SDSL Configuration
menu to set the SDSL speed to Auto Cycle for connecting to a Nokia
DSLAM.
The IAD saves the configuration and redisplays the SDSL Configuration
menu.
DSLAM.
The IAD saves the configuration and redisplays the SDSL Configuration
menu.
Set SDSL Speed to
Auto Sense (Copper
Mountain)
To select Auto Sense
− Copper Mountain DSLAM, type “3” on the SDSL
Configuration menu (Figure 4.8) to set the SDSL speed to Auto Sense for
connecting to a Copper Mountain DSLAM. The IAD saves the configuration
and redisplays the SDSL Configuration menu.
connecting to a Copper Mountain DSLAM. The IAD saves the configuration
and redisplays the SDSL Configuration menu.
Enable/Disable
Conexant Autobaud
Mode
1
Type “4” on the SDSL Configuration menu (Figure 4.8) to enable or
disable Conexant Autobaud mode. The IAD displays the current setting and
prompts you to change it.
2
Type “E” to enable or “D” to disable Autobaud mode. The IAD saves the
configuration and redisplays the SDSL Configuration menu.
Set SDSL Sync Delay
(Lucent)
To set the SDSL Sync Delay (Lucent), follow the steps listed below.
1
Type “5” on the SDSL Configuration menu (Figure 4.8) to enable Sync
Delay, which is paired with Conexant Autobaud mode. The IAD displays
the current Autobaud setting and prompts you to change it.
2
Type “E” to enable or “D” to disable Autobaud mode. If you disable
Autobaud, you must set the SDSL data rate manually. The IAD prompts
you to enter the SDSL Rate.
3
Enter the rate (144 to 2320 kbps, evenly divisible by 8) and press Enter.
4
The IAD saves the configuration and redisplays the SDSL Configuration
menu.
Set SDSL to AccessLan
CPE Mode
Type “6” on the SDSL Configuration menu (Figure 4.8) to set the IAD to
CPE Mode for connecting to an AccessLan DSLAM. The IAD saves the
configuration and redisplays the SDSL Configuration menu.
configuration and redisplays the SDSL Configuration menu.
Set SDSL IMAS
DSLAM (Nortel)
1
Type “7” on the SDSL Configuration menu (Figure 4.8) to set the SDSL
first-try speed for connecting to an IMAS (Nortel) DSLAM. The IAD
displays the IMAS First Speed Option menu (Figure 4.9).