Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
59
Figure 4.19
Configure S-Bits Menu
Configure Loopback Type “4” on the E1 Configuration menu to select Configure Loopback,
which will displace the menu shown in Figure 4.20
Figure 4.20
Select Loopback Configuration
The Outward Payload Loopback loops the data after the T1 framer back to the
network. The Outward Line Loopback loops the data before the T1 framer
back to the network. The Inward Loopback loops the data after the T1 framer
back to the user.
network. The Outward Line Loopback loops the data before the T1 framer
back to the network. The Inward Loopback loops the data after the T1 framer
back to the user.
Configure Transmit or
Receive Channels
Type “5” on the E1 Configuration menu to select Configure Transmit
Channels or “6” to Configure Receive Channels. Figure 4.21 shows the
Transmit Channel Configuration menu. The Receive Channel Configuration
menu is the same except that it shows the Rx Channels Enabled.
menu is the same except that it shows the Rx Channels Enabled.