Zhone 2000 ユーザーガイド
62
2 0 0 0 - A 2 - G B 2 3 - 0 0
Set ADSL Standard
1
Type 1 to select Configure ADSL Standard. The IAD displays the ADSL
Standards menu.
Figure 4.25
ADSL Standards Menu.
2
Type the option corresponding to the ATM Standard. The IAD sets the
standard you select and displays the menu.
NOTICE:
If no default route is configured on the IAD, the first PPP interface that
completes negotiation will be assigned as the default interface. If
multiple PPP interfaces are configured, this could result in the wrong
interface being assigned as the default. This applies to PPPoA and
PPPoE.
completes negotiation will be assigned as the default interface. If
multiple PPP interfaces are configured, this could result in the wrong
interface being assigned as the default. This applies to PPPoA and
PPPoE.
Configure Physical Interface
− SHDSL
The tasks described in this section all begin on the SHDSL Configuration
menu (Figure 4.26). You should review and update each of these options as
necessary, and always reset the IAD when you finish SHDSL configuration.
To configure the SHDSL interface, Type “2” (Configure Physical Interface)
menu (Figure 4.26). You should review and update each of these options as
necessary, and always reset the IAD when you finish SHDSL configuration.
To configure the SHDSL interface, Type “2” (Configure Physical Interface)
on the WAN Configuration menu (Figure 4.6) to display the SHDSL
Configuration menu.
Configuration menu.
Figure 4.26
SHDSL Configuration Menu