Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
71
NOTICE:
AAL2/LES encapsulation is used for AAL2/LES-CAS and AAL2/LES
ELCP voice applications.
ELCP voice applications.
Delete PVC
To delete a PVC, follow the steps below.
1
Type “3” on the ATM PVC Configuration menu (Figure 4.31) to select
Delete PVC. The IAD displays the port list and a prompt.
2
Type the port number to delete and press Enter.
3
To delete the PVC, type “Y”, or cancel the deletion by typing any other
character. The IAD saves the configuration and displays the PVC
Configuration menu where you may continue with other PVC management
tasks.
Show Current PVCs
1
1
To display a list of current PVCs, type “4” on the ATM PVC
Configuration menu (Figure 4.31) to display the port table with associated
PVCs:
2
When you have finished viewing the list, press any key to return to the
ATM PVC Configuration menu.
Configure ATM Options
To configure ATM options, type “4” on the WAN Configuration menu
(ATM) to display the ATM Configuration menu (Figure 4.37). Current
datalink protocol on the WAN Configuration menu must be set to ATM to see
the ATM Configuration menu. Remember always to reset the IAD when you
finish ATM configuration. (You may wait to reset until all changes have been
made.)
datalink protocol on the WAN Configuration menu must be set to ATM to see
the ATM Configuration menu. Remember always to reset the IAD when you
finish ATM configuration. (You may wait to reset until all changes have been
made.)
Figure 4.37
ATM Configuration Menu
Each of the options on this menu is described in detail below.
Configure Payload Scrambling
You must enable payload scrambling (which is disabled by default) for the
IAD to connect to a DSLAM that uses payload scrambling. To enable or
disable payload scrambling, follow the steps below:
IAD to connect to a DSLAM that uses payload scrambling. To enable or
disable payload scrambling, follow the steps below: