Zhone 2000 ユーザーガイド
74
2 0 0 0 - A 2 - G B 2 3 - 0 0
Figure 4.40
Frame Relay Encapsulation Configuration Menu
3
Type the option corresponding to the encapsulation method you intend to
use. The IAD displays the Frame Relay DLCI Options menu (Figure 4.41).
Figure 4.41
Frame Relay DLCI Options Menu
NOTICE:
To continue without configuring CIR or FRF.12 Fragmentation, press
Escape. CIR is not required for full bandwidth circuits.
Escape. CIR is not required for full bandwidth circuits.
Configure Transmit
CIR
To configure Transmit CIR, follow the steps below.
1
Type “1” on the Frame Relay DLCI Options menu to select Configure
Transmit CIR. The IAD prompts you to enter the Committed Burst Size
(Bc).
2
Type the Bc in number of bits. The IAD prompts you to enter the Circuit
Throughput.
3
Type the Circuit Throughput and press Enter. The IAD prompts you to enter
the Excess Burst Size (Be).
4
Type the excess burst value in number of bits and press Enter. The IAD
displays the Frame Relay DLCI Options menu (Figure 4.41).
5
Press Escape to return to the Frame Relay DLCI Config menu and continue,
or proceed to the next section.
Configure Receive CIR To configure Receive CIR, follow the steps below.
1
Type “2” on the Frame Relay DLCI Options (Figure 4.41) menu to select
Configure Receive CIR. The IAD prompts you to enter the Bc.
2
Type the Bc in number of bits. The IAD prompts you to enter the Circuit
Throughput.