Zhone 2000 ユーザーズマニュアル

- 107 -

To display information about the data in the DNS cache, type S. When 
DNS Client is enabled, the IAD displays the following information:

392 Total Requests
117 Requests Serviced From Cache
295 Requests Sent to Server
2 Server Timeouts
293 Server Good Responses
3 Server Not Found Responses
19 Server Unexpected Responses
1 Errors Sending to Server

Press any key to return to the DNS Client menu when you’re done 
reviewing the information.

To enable or disable DHCP Client on an interface, follow these steps:

1. Type H on the Router Configuration menu to select Configure DHCP 

Client.

2. If more than one WAN port is installed or more than one PVC or DLCI 

exists, the IAD displays the interfaces on this IAD (sample shown):
Available Interfaces:

1. SDSL
2. 10/100BaseT Ethernet
0. (Abort)

Type the interface number to set.

3. The IAD displays the port table for this interface and prompts for a port:

Port VPI VCI Encapsulation Type

PCR

Service

1

0

40 RFC 1483 (with LLC Encap)3641

UBR

Total = 3641 cps

Maximum PCR this interface can support = 3622 cps

Select Port: [1-8]

Type the port to set and press Enter.

4. The IAD displays the status of the slot and port you’re setting, and a 

prompt:
DHCP Client for SDSL, Port 1 is currently DISABLED

Enter E to Enable, D to Disable:

Type E to enable DHCP Client on this port, or D to disable it.

5. The IAD saves the changes and displays the Router Configuration 

menu.

6. Repeat these steps for each remaining port to set.
7. Continue with other configuration tasks, or press Escape to return to 

the Main menu.

8. Reset the IAD (page

) when you finish router configuration.