Zhone 2000 ユーザーズマニュアル

- 128 -

Configuring the voice path settings involves several tasks. These are all 
displayed and accessed on the Voice Configuration menu (displayed by 
typing P on the Main menu). 

Tasks in this chapter are described beginning at the Voice Configuration 
menu.

To select a voice gateway:

1. Type V on the Voice Configuration menu to select Set Voice Gateway.

The IAD displays the Voice Gateway Selection menu, which contains a list 
of valid voice gateways for this IAD. 

*******************************************

Voice Configuration

*******************************************

V. Set Voice Gateway
J. Set Jitter Delay
D. Display Jitter Delay
S. Set Start Mode (Loop Start/Ground Start)
T. Set SLIC Control Mode
U. Set Compander Mode (u-Law, A-Law)
O. Set On Hook Transmission Mode of Ground Start Lines
L. Set Idle Voltage Mode of Loop Start Lines
M. Set Debug Mode
E. Configure Echo Cancellation Default Settings
G. Set Loop Gain
C. Set Country Mode

 

You must sign on as Supervisor to configure voice path 
settings.

Be sure to reset the IAD when you are done making changes 
to the voice path settings. Resetting the IAD causes the 
configuration changes to take effect.

LAN LINK

LAN ACT

WAN LINK

VOICE

POWER

Figure 7-2 displays the list of valid gateways for all IADs 
except those with an ISDN telephone interface. The order of 
gateways varies by IAD.