Zhone 2000 ユーザーズマニュアル

- 193 -

To permanently reset statistics for a specific protocol, type the option. 

The IAD immediately resets all statistics for the specified protocol, and 
displays the menu.

Continue resetting network statistics, or press Escape to return to the 
Network Statistics menu.

Type I on the Reports menu to display interface statistics reports. The 
Interface Statistics menu contains commands to display information about 
the packets handled between layer 2 and layer 3 on a per port basis, and 
to clear statistics for specific protocols.

To display specific interface statistics, first select an interface and 
optionally a port. The IAD then displays the report, as shown in these 
steps:

1. The IAD displays the interfaces on this IAD, and a prompt:

Available Interfaces:

1. T1/E1
2. 10/100BaseT Ethernet
0. (Abort)

Type the number of the interface.

2. If there is more than one port, the IAD displays the port list and prompt:

Port

DLCI

Encapsulation

1

18

Proprietary Voice DLCI

Select Port: [1-8]

Type the port number and press Enter.

3. The IAD displays the Interface Statistics menu: 

To display a specific report, type the option. 

C. Clear ICMP Statistics
G. Clear IGMP Statistics
I. Clear IP Statistics
P. Clear PIM Statistics
T. Clear TCP Statistics
U. Clear UDP Statistics

 

The commands that display on the Network Statistics menu 
vary, based on the WAN module and configuration of the IAD.

A. Display ARP Statistics
I. Display Interface Statistics
B. Display Bridge Statistics
D. Display DLCI Statistics
Z. Clear a Statistic
Z. Clear ATM PVC Statistics

Option D displays “PVC 
Statistics” when IAD is 
configured for ATM.

(Ethernet only)