Zhone 2000 ユーザーズマニュアル

- 41 -

The Debug menu contains commands to set various debugging options. 
Debugging should only be enabled specifically during a debugging or 
monitoring session, and disabled when the session is complete. Enabling 
multiple debugging options simultaneously slows IAD performance.

Debugging options may be enabled and disabled without resetting the 
IAD. To display the Debug menu, type G on the Utilities menu.

To perform a task, type the option and proceed to the appropriate section, 
following.

To modify the Ethernet MAC address, perform these steps:

1. Type M on the Debug menu. The IAD displays the following message:

This will change the factory setting for the ENET 
Mac Address.

Are you sure?

2. Type Y to proceed, or any other character to abort.

When you proceed, the IAD displays the current MAC address for the 
Ethernet port and prompts for a new one:
Current Ethernet Address= 00-E0-75-1C-0E-18

New MAC Address

= *-**-**-**-**-**

3. Type the new MAC address. Press Escape any time to abort this task.
4. Reset the IAD (page

) for the new MAC address to take effect.

When you enable PPP debugging, the IAD displays PPP debug 
messages. To enable or disable PPP debugging, follow these steps:

1. Type E on the Debug menu. The IAD displays the PPP debug status:

PPP Debug Mode is currently DISABLED

2. Type E to enable PPP debugging, or type D to disable it.

The IAD sets PPP debug mode to the setting you entered, and displays 
the Debug menu.

 

Debugging commands are reserved for use by Paradyne 
network engineers.

***************************************************

Debug Menu

***************************************************

M. Set Ethernet MAC
E. Enable/Disable PPP debug mode
S. Enable/Disable STP debug mode
I. Enable/Disable DHCP Client debug mode
Q. Display Error Dump