Zhone 5100 参照マニュアル

ページ / 186
Commands common to all interfaces
Vpacket 5100/6100 Series Reference Manual
                                                                                                   
59
Example 2:
In this example, the voice IP address is set to the WAN IP address.
Viewing IP addresses
You can view all IP addresses configured on a 5100/6100 VDR by issuing the show ip command. 
Syntax: show ip
Example:
In this example, all of the interfaces and corresponding information for the 5100/6100 VDR 
deployment as shown in Figure 3-1 on page 54. The active Ethernet or LAN interface has an IP 
address of 10.10.10.254 with a subnet mask of 255.255.255.0. The configured (CONFIG) WAN 
interface is set to IP address 205.176.94.11 with a subnet mask of 255.255.255.0 and the voice IP 
address is set to match the WAN interface IP address. When the voice IP address matches the 
WAN address, the voice traffic is run through the WAN interface. The configured (ACTIVE) 
default gateway is set to 10.10.10.254. The configured interfaces change to active state interfaces 
after you issue the commit (ip) and save commands.
VPacket# set ip voice wan
VPacket#
VPacket# show ip
ACTIVE indicates this is the current operational setting
CONFIG indicates this has been configured but not activated
-------------------------IP INTERFACE----------------------
       INTERFACE NAME      IP ADDRESS          NET MASK
ACTIVE lan                 10.10.10.1          255.255.240.0     NATed
ACTIVE lan                 13.13.13.254        255.255.255.0     NATed
ACTIVE lan                 15.15.15.254        255.255.255.0     NATed
CONFIG wan                 205.176.94.11       255.255.255.0
ACTIVE Default Gateway     10.10.10.254
ACTIVE Voice Ip Address    205.176.94.11
-----------------------------------------------------------
VPacket#