Zhone 5100 参照マニュアル

CHAPTER 3
Interfaces

Before setting the wan data protocol and encapsulation, you need to define the type of DSLAM 

you want to configure. You can set the 6100 VDR to connect with a Copper Mountain DSLAM  

by issuing the set wan dslam command.
Syntax: set wan dslam <CopperMountain | LucentStinger>
Argument:

CopperMountain | LucentStinger        type of DSLAM

Example 1:

In this example, the DSLAM type is set to Copper Mountain. The change is committed,  saved 

and then the unit is reset.
Example 2:

In this example, the DSLAM type is set to Lucent Stinger. The change is saved and then the unit 

is reset. You also need to commit and save the changes and then reset the unit.

You can set the encapsulation type for the WAN interface (voice and data) by issuing the set wan 

encap command. DSLAMs (SDSL Copper Mountain) utilize 1483Bridged or 1483Routed.
Syntax: set wan encap <1483Bridged | 1483Routed | 1490Bridged | 1490Routed>
Argument:

1483Bridged | 1483Routed | 1490Bridged |1490Routed

the Lucent Stinger supports 1483Bridged or 1483Routed; Copper Mountain 

DSLAM supports 1483Bridged

Example 1:

In this example, the WAN encapsulation is set to 1483Bridged to interoperate with a Copper 

Mountain DSLAM. You also need to commit and save the changes and then reset the unit.

VPacket# set wan dslam CopperMountain

VPacket# 

VPacket# set wan dslam LucentStinger

VPacket# save

VPacket# reset

VPacket# 

VPacket# set wan encap 1483Bridged

VPacket# save

VPacket# reset