Zhone 5100 インストールガイド
CHAPTER 3
Port connections
Port connections
26
Vpacket 5100/6100 Series Installer’s Guide
Port connection for data services
You can connect the 5100/6100 VDR to a LAN through the auto-sensing full-duplex
10/100BaseT Ethernet port and to a WAN through the single/Dual T1, SDSL, or Ethernet
port(s) (specific ports and number of ports vary by model).
Connecting to an Ethernet LAN
This section describes how you can connect your 5100/6100 VDR to a hub or switch. To connect
to Ethernet ports on hubs or switches, you should use a straight-through cable or another cable
that conforms to the pin assignments in Appendix C.
To connect the VDR to an Ethernet LAN
1. Configure and confirm that the PCs involved have valid, appropriate IP addresses.
2. Connect one end of an Ethernet cable to the rear Ethernet port (to the left of the PSTN port)
2. Connect one end of an Ethernet cable to the rear Ethernet port (to the left of the PSTN port)
on the VDR and the other end of the cable to a 10/100BaseT port on an Ethernet hub or
switch.
Figure 3-7 shows an example of these connections.
Figure 3-5. Connecting to an Ethernet LAN
Connecting to an Ethernet Wide Area Network
This section describes how you can connect your 5100/6100 VDR to an Ethernet WAN switch.
To make the connection, you should use a straight-through cable or another cable that conforms
to the pin assignments in Appendix C.
To connect the VDR to an Ethernet WAN
1. Configure and confirm that the PCs involved have valid, appropriate IP addresses.
2. Connect one end of an Ethernet cable to the rear Ethernet WAN port and the other end of
2. Connect one end of an Ethernet cable to the rear Ethernet WAN port and the other end of
the cable to a 10/100BaseT port on an Ethernet WAN switch. See Figure 3-6 on page 27.
Ethernet hub
5100/6100 VDR
Power Alarm
Status
LIFELINE
PSTN
Ethernet
port
Straight-
through
cable