Zhone 6210 ユーザーガイド

ページ / 72
6210-A2-GB23-00
January 2005
B
 Important Safety Instructions
1. Read and follow all warning notices and instructions marked on the product or included in the manual.
2. Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation of the product and to 
protect it from overheating, these slots and openings must not be blocked or covered.
3. Do not allow anything to rest on the power cord and do not locate the product where persons will walk on the power 
cord.
4. Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous high 
voltage points or other risks. Refer all servicing to qualified service personnel.
5. General purpose cables are used with this product for connection to the network. Special cables, which may be 
required by the regulatory inspection authority for the installation site, are the responsibility of the customer. Use a 
UL Listed, CSA certified, minimum No. 24 AWG line cord for connection to the Digital Subscriber Line (DSL) 
network.
6. When installed in the final configuration, the product must comply with the applicable Safety Standards and 
regulatory requirements of the country in which it is installed. If necessary, consult with the appropriate regulatory 
agencies and inspection authorities to ensure compliance.
7. A rare phenomenon can create a voltage potential between the earth grounds of two or more buildings. If products 
installed in separate buildings are interconnected, the voltage potential may cause a hazardous condition. Consult 
a qualified electrical consultant to determine whether or not this phenomenon exists and, if necessary, implement 
corrective action prior to interconnecting the products.
8. Input power to this product must be provided by one of the following: (1) a UL Listed/CSA certified power source 
with a Class 2 or Limited Power Source (LPS) output for use in North America, or (2) a certified transformer, with a 
Safety Extra Low Voltage (SELV) output having a maximum of 240 VA available, for use in the country of 
installation.
9. In addition, since the equipment is to be used with telecommunications circuits, take the following precautions:
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the 
network interface.
Use caution when installing or modifying telephone lines.
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of 
electric shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
CE Marking
When the product is marked with the CE mark on the equipment label, a supporting Declaration of Conformity may be 
downloaded from the Paradyne World Wide Web site at www.paradyne.com. Select Library 
 Technical Manuals  
FCC Part 15 Declaration
An FCC Declaration of Conformity may be downloaded from the Paradyne World Wide Web site at www.paradyne.com. 
Select Support -> Technical Manuals -> Declarations of Conformity.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device 
may not cause harmful interference, and (2) this device must accept any interference received, including interference 
that may cause undesired operation.
The authority to operate this equipment is conditioned by the requirement that no modifications will be made to the 
equipment unless the changes or modifications are expressly approved by the responsible party. 
!