Zhone 5246 インストール手順
6
Installing the DSL Access Wiring
The local loop terminates at the punchdown block or NID. Wiring must be connected
from the customer premises side of the punchdown block or the NID to an RJ11 jack.
Typically, the punchdown block is installed in commercial locations and the NID is
installed in residential locations.
from the customer premises side of the punchdown block or the NID to an RJ11 jack.
Typically, the punchdown block is installed in commercial locations and the NID is
installed in residential locations.
Procedure
1. Access the punchdown block or NID.
2. Disconnect the DSL access pair from the local loop.
!
WARNING:
Do not continue unless the DSL access line from the local loop has been
disconnected at the NID or punchdown block. Refer to
disconnected at the NID or punchdown block. Refer to
Important Safety
Instructions on page 19.
A punchdown block is used without a POTS splitter in the following example.
A
B
C
D
DSL
Access
from Local
Loop
Access
from Local
Loop
Wiring to
DSL Jack
DSL Jack
Bridge Clip
Punchdown Block
97-15348
Demarcation Point
Customer Premises