Zhone 6210 ユーザーガイド

ページ / 46
Hotwire 6210, 6211, and 6381 User’s Guide 
6.  Select the quality of service (QOS). Leave the default value if you are unsure or the ISP did not provide this 
information.  
 
Figure 4-4. Bridged Connection Setup 
 
To complete the connection you must now click the Apply button. The Apply button will temporarily save this 
connection. To make the change permanent, click on Tools (at the top of the page) and select System Commands. At 
the System Commands page, click on Save All
 
4.4.1.2 
PPPoA Connection Setup 
 
PPPoA is defined in the Internet standard RFC 2364. It is a method of encapsulating PPP packets over ATM cells 
which are carried over the DSL line. PPP (Point-to-Point Protocol) is a method of establishing a network session 
between network hosts. It usually provides a mechanism of authenticating users. LLC and VC are two different 
methods of encapsulating the PPP packet. Contact your ISP to make sure which encapsulation is being supported.  
By selecting PPPoA, you are forcing your modem to act as the termination point for the PPPoA connection. This frees 
up your PC resources and allows multiple users to utilize the PPPoA connection. 
To configure the modem for PPPoA: 
1.  Click on Setup and then click on New Connection. The default PPPoE connection setup is displayed.  
2.  At the Type field select PPPoA and the PPPoA connection setup page is displayed. Figure 4-5 illustrates a typical 
PPPoA configuration.  
3.  Give your PPPoA connection a unique name. The name must not have spaces and cannot begin with numbers. In 
this case the unique name is PPPOA1.  
4.  Select the encapsulation type (LLC or VC); if you are not sure just use the default mode.  
5.  Select the VPI and VCI settings; your DSL service provider or your ISP will supply these; in this case the DSL 
service provider is using 0,40.  
6.  Select the quality of service (QOS). Leave the default value if your ISP did not provide this information.  
 
Following is a description of the different options: 
•  Username – The username for the PPPoA access. This is provided by your DSL service provider or your ISP. 
•  Password – The password for the PPPoA access. This is provided by your DSL service provider or your ISP. 
6210-A2-GB21-10                                                                    April 2004                                                                                              25