Zhone 6210 ユーザーガイド

ページ / 46
Hotwire 6210, 6211, and 6381 User’s Guide 
2.  Under Advanced, select Access Control. The Access Control screen appears. All Access Control rules have 
precedence over rules that were added via the port-forwarding page.   
The Apply button will temporarily save these settings. To make the change permanent, click on Tools (at the top of 
the page) and select System Commands. At the System Commands page, click on Save All
 
4.6.4 
LAN clients 
To add a LAN client: 
1.  From the Home screen, click Advanced. 
2.  Under Advanced, select LAN Clients. If DHCP is used, all DHCP clients are automatically assigned. If a fixed IP 
address server is on the LAN and you want this server to be visible via the WAN, you must add its IP address. 
Once the IP address has been added to you can apply Port Forwarding rules to this IP address. 
The apply button will temporarily save these settings. To make the change permanent, click on Tools (at the top of the 
page) and select System Commands. At the System Commands page, click on Save All
 
4.6.5 
Bridge Filters 
The bridge filtering mechanism provides a way for the users to define rules to allow or deny frames through the bridge 
based on source MAC address, destination MAC address and/or frame type. When bridge filtering is enabled, each 
frame is examined against the defined filter rules sequentially, and when a matched is determined, the appropriate 
filtering action (allow or deny) is performed. The bridge filter will only examine frames from interfaces which are part 
of the bridge itself. Twenty filter rules are supported with bridge filtering.  
To enable Bridge Filters: 
1.  From the Home screen, click on Advanced. 
2.  Under Advanced, select Bridge Filters.  Figure 4-15 illustrates a typical Bridge filter configuration. 
The User Interface for Bridge Filter allows the user to add, edit, and delete, as well as enable the filter rules. To add 
rules, define the source MAC address, destination MAC address, and frame type with the desired filtering action 
(allow or deny), and click on the Add button. The MAC address must be in a xx-xx-xx-xx-xx-xx format, with 00-00-
00-00-00-00 or blanks meaning any address.  
To edit or modify an existing filter rule, select the desired rule created previously in the Edit select box. The selected 
filter rule appears in the top section, as with the Add procedure. Make the desired change to the MAC address, frame 
type and access type, and click on Apply. 
To delete a filter rules, select the filter rule entry to delete in the Delete selection box. Note that multiple deletions are 
possible. Once all the desired filter rules are selected for deletion, click on the Apply button. The Select All select box 
can also be used to delete the entire filter rule. It provides a quick method of selecting all filter rules for deletion. 
The Enable Bridge Filters button allows you to enable or disable bridge filtering. It can be set or unset during any add, 
edit, or delete operation. It can also be set or unset independently by pressing the Apply button. 
6210-A2-GB21-10                                                                    April 2004                                                                                              35