Zhone 6212-a2 ユーザーズマニュアル

ページ / 101
 
 
6212-A2-GB20-00                               May 2004                                                           41
 
5.2 VLAN 
To configure the VLAN function, click on VLAN from the Advanced menu bar.  VLAN is disabled 
by factory default.  To enable it, click on Enable, then click on the Set button. Then you can 
proceed to create the VLAN groups.  The router supports four VLAN groups (1–4).  You can 
choose and add different Ethernet ports to the PVC running in RFC 1483 bridged mode.      
 
Parameters and buttons 
Ports 0, 1, 2, and 3 respectively represent Ethernets 4, 3, 2, and 1.  The PVC field displays the 
options of the PVCs set up in RFC 1483 Bridged mode (refer to section 4.4, WAN Setup).  Click 
on the Set button to apply the settings, or click on the Clear button to delete a VLAN group. 
 
 
 
5.3 DHCP 
The Dynamic Host Configuration Protocol (DHCP) provides a centralized approach to allocating 
IP addresses. It allows IP addresses to be dynamically assigned on an as needed basis, from a 
pool of addresses. The DHCP server is enabled by factory default with the default IP address of 
the eth0 to be 192.168.1.1/24.