Zhone 6212-a2 ユーザーガイド

ページ / 70
3. Using the Web Interface
6212-A2-GB22-00
January 2005
3-9
Tools (at the top of the page) and select System Commands. At the System 
Commands page, click on Save All.
Static Connection Setup
A static connection is used whenever a known static IP is assigned. The 
accompanying information such as the subnet mask and the default gateway 
should also be specified. Up to three Domain Name Server (DNS) addresses can 
also be specified. These servers give you access to other web servers. The valid 
IP addresses range is  1.0.0.0 to 223.255.255.254. 
To configure the router for a Static connection:
Procedure
1. Click on Setup and then click on New Connection. The default Static 
connection setup is displayed. 
2. At the Type field select Static from the drop-down list. The Static Connection 
Setup page is displayed. 
3. Give your Static connection a unique name. The name must not have spaces 
and cannot begin with numbers. 
4. Optionally enable Network Address Translation (NAT) and the Firewall options. 
Firewall and NAT services must be enabled. See 
5. Select a PVC Sharing type of Disable, Enable, or VLAN. 
6. Select or enter a VPI and VCI (as supplied by your DSL service provider or 
your ISP), or click in Auto PVC. (Auto PVC causes the router to perform  
automatic VPI/VCI detection as defined in DSL forum TR-068.) For VLAN, 
specify a VLAN ID and priority.
7. Select NAT and Firewall if you want them active for this connection. Firewall 
and NAT services must be enabled. See 
8. Select the encapsulation type (LLC or VC). If you are not sure which to use, 
just use the default mode. 
9. Based upon the information your ISP provided, enter your assigned IP 
Address, Subnet Mask, Default Gateway (if provided), and Domain Name 
Services (DNS) address (if provided). Specify the VPI and VCI settings. Your 
DSL service provider or your ISP will supply these.  
10. Select the quality of service (QOS). Leave the default value if your ISP did not 
provide this information.  
11. Set the mode to Bridged or Routed as instructed by your ISP.