Zhone 6212-a2 ユーザーガイド

ページ / 70
3. Using the Web Interface
3-16
 
 January 2005
6212-A2-GB22-00
To change the router's IP address:
Procedure
1. From the Home screen, click on Setup. 
2. Under LAN Setup, select LAN Configuration. The LAN Group 1 Configuration 
screen appears, as shown in 
3. Click on “Use the following Static IP Address”. 
4. Enter a new IP Address and Netmask.
The Apply button will temporarily save these settings. To make the change 
permanent, click on Tools (at the top of the page) and select System Commands. 
At the System Commands page, click on Save All.
Ethernet Switch
To set the speed and duplex mode of the LAN ports:
Procedure
1. From the Home screen, click on Ethernet Switch. The Ethernet Switch screen 
appears. 
2. For Physical Port1 through Physical Port4 (LAN1 through LAN4), select a 
mode and speed from the Set Value drop-down list. Select Auto to negotiate 
the Ethernet duplex mode and speed with attached equipment that supports 
auto-negotiation. 
The current configured or negotiated settings are displayed under Fallback Value.
The Apply button will temporarily save the Ethernet Switch settings. To make the 
change permanent, click on Tools (at the top of the page) and select System 
Commands. At the System Commands page, click on Save All.  
Figure 3-11. Ethernet Switch