Zhone 6301 インストール手順
14
Configuration Setup
If a CD-ROM is included with your ReachDSL router, proceed to
The Console connection can be used to locally configure the router with a
VT100-compatible terminal or PC running a terminal emulation program. Refer to
VT100-compatible terminal or PC running a terminal emulation program. Refer to
on page 10 for cabling.
Verify the terminal settings:
Data rate is set to 19.2 Kbps (19200 bps).
Character length is set to 8.
Parity is set to None.
Stop bits is set to 1.
Flow control is set to Off or None.
Character length is set to 8.
Parity is set to None.
Stop bits is set to 1.
Flow control is set to Off or None.
Accessing the Router
When the local console connection is first established, access control to the ReachDSL
router displays an initial prompt of Login>.
router displays an initial prompt of Login>.
Procedure
1. At the initial prompt of Login>, enter the factory default Login ID of paradyne.
2. At the password> prompt, enter the factory default Password of abc123.
3. At the next prompt for System ID, the factory default is CUSTOMER>.
Type show system to display hardware/firmware information and Selftest Results
(optional).
(optional).
Refer to the Hotwire DSL Routers User’s Guide for configuration settings and command
line entries.
line entries.
Increasing the Number of End-User Systems
A single PC is attached to the router by using an Ethernet crossover cable.
The router can support differing numbers of end-user systems, depending on the
functions that are enabled and traffic loading. Typical configurations provide support for
up to 32, 64, or 256 hosts (end-user systems).
functions that are enabled and traffic loading. Typical configurations provide support for
up to 32, 64, or 256 hosts (end-user systems).
To increase the number of PCs, connect all PCs to an Ethernet hub using a straight-
through cable. The number of end-user systems can be increased with the use of
subnets utilizing static addressing or by using a default gateway connection.
through cable. The number of end-user systems can be increased with the use of
subnets utilizing static addressing or by using a default gateway connection.