Zhone 6212-a2 ユーザーズマニュアル

To set up your router with a basic configuration, select Setup. Figure 3 illustrates the setup page. The page is broken 
into two subsections: the WAN configuration and the LAN configuration. 

 

 

Figure 3 (Setup page) 

Before configuring the router, there are several concepts that you should be familiar with on how your new router 
works. Please take a moment to familiarize yourself with these concepts, as it should make the configuration much 
easier.  

The Wide Area Network (WAN) connection is also referred to as a broadband connection. The WAN connection is 
different for every WAN supplier. Most of the configuration you will perform will be in this area.  

You have your own Local Area Network (LAN) connections. This is where you plug in your local computers to the 
router. The router is normally configured to automatically provide all the PCs on your network with Internet addresses.  

 

Before the router will pass any data between the LAN interface(s) and the WAN interface, the WAN side of the 
modem must be configured. Depending upon your service provider, you will need some (or all) of the information 
outlined below before you can properly configure the WAN: 

•  Your DSL line VPI and VCI 

•  Your DSL encapsulation type and multiplexing 

•  Your DSL training mode (default is MMODE) 

21