Zhone 6212-a2 ユーザーズマニュアル

ページ / 45
6212-A2 and 6382-A1 ADSL Router User’s Guide 
 
 
 
Figure 17 (Static Routing) 
Click on the Apply button to temporarily save this configuration. To make the change permanent, click on Tools (at the 
top of the page) and select System Commands. At the system commands page, click on Save All
 
4.6.9 Dynamic 
Routing 
Dynamic Routing allows the router to automatically adjust to physical changes in the network. The router, using the 
RIP protocol, determines the network packets’ route based on the fewest number of hops between the source and the 
destination. The RIP protocol regularly broadcasts routing information to other routers on the network.  
The Direction determines the direction that RIP routes will be updated. Selecting In means that the router will only 
incorporate received RIP information. Selecting Out means that the router will only send out RIP information. 
Selecting both means that the router will incorporate received RIP information and send out updated RIP 
information.   
The protocol is dependent upon the entire network. Most networks support Rip v1. If RIP v1 is selected, routing data 
will be sent in RIP v1 format. If Rip V2 is selected, routing data will be sent in RIP v2 format using subnet 
broadcasting. If Rip V1 Compatible is selected, routing data will be sent in RIP v2 format using multicasting. 
 
To enable Dynamic Routing, go to the Home screen and click on Advanced. Under Advanced, select Dynamic 
Routing. Figure 18 illustrates a typical Dynamic Route.  
 
  
37