Zhone 7995 ユーザーガイド
6. Monitoring and Troubleshooting
7990-A2-GB20-20
September 2004
6-3
Health and Status Messages
The messages in
Table 6-1, Health and Status Messages
, can appear in the first
column of the System and Test Status screen. The highest priority Health and
Status message also appears on all ATI screens on the bottom right.
Status message also appears on all ATI screens on the bottom right.
Table 6-1.
Health and Status Messages (1 of 3)
Message
What Message Indicates
What To Do
AIS at G.703
An Alarm Indication Signal
(AIS) is being received by the
G.703 interface.
(AIS) is being received by the
G.703 interface.
A fault exists in the network
connected to the G.703 port.
Contact network provider.
connected to the G.703 port.
Contact network provider.
DeviceFailed yyyyyyyy
An internal error has been
detected by the operating
software. yyyyyyyy indicates
the 8-digit hexadecimal
failure code.
detected by the operating
software. yyyyyyyy indicates
the 8-digit hexadecimal
failure code.
1. Provide the 8-digit failure
code shown (yyyyyyyy) to
your service representative.
your service representative.
2. Reset the unit to clear the
condition and message.
Download Failed
A firmware download was
interrupted.
interrupted.
Repeat the download.
DSL Attenuation
Threshold
Threshold
The attenuation value for the
DSL interface has fallen
below the configured
threshold.
DSL interface has fallen
below the configured
threshold.
1. Reconfigure the unit to a
lower DSL Attenuation
Threshold.
Threshold.
2. Contact network provider.
DSL CRC Threshold
The number of counted
CRCs for the DSL interface
has exceeded the configured
threshold.
CRCs for the DSL interface
has exceeded the configured
threshold.
1. Reconfigure the unit to a
higher DSL CRC Threshold.
2. Contact network provider.
DSL ES Threshold
The number of errored
seconds for the DSL interface
has exceeded the configured
threshold.
seconds for the DSL interface
has exceeded the configured
threshold.
1. Reconfigure the unit to a
higher DSL ES Threshold.
2. Contact network provider.
DSL LOSW Threshold
A Loss of Sync Word defect
is present for at least 2.5
seconds.
is present for at least 2.5
seconds.
Contact network provider.
DSL Margin Threshold
The signal-to-noise margin
has dropped below the
configured threshold.
has dropped below the
configured threshold.
1. Reconfigure the unit to a
lower DSL Margin Threshold.
2. Contact network provider.
DSL SES Threshold
The number of severely
errored seconds for the DSL
interface has exceeded the
configured threshold.
errored seconds for the DSL
interface has exceeded the
configured threshold.
1. Reconfigure the unit to a
higher DSL SES Threshold.
2. Contact network provider.
DSL UAS Threshold
The number of unavailable
seconds for the DSL interface
has exceeded the configured
threshold.
seconds for the DSL interface
has exceeded the configured
threshold.
1. Reconfigure the unit to a
higher DSL UAS Threshold.
2. Contact network provider.