Zhone 2004 ユーザーガイド
4-50
2 0 0 0 - A 2 - G B 2 2 - 0 0
5
The IAD will display the SIP signaling parameters, and you may configure
the VPI/VCI. This interface/own IP address is used to send/receive SIP
signaling packets and is the same interface/port/connection configured
elsewhere in the IAD.
the VPI/VCI. This interface/own IP address is used to send/receive SIP
signaling packets and is the same interface/port/connection configured
elsewhere in the IAD.
6
Enter the starting RTP to be used for voice transport. This interface/own IP
address is used for RTP voice streams. The starting port number is the port
number used by the first phone line, and the port numbers increment by two
for each line. You may type in a new value and then press Enter, or press
Enter without typing in a new value to retain the old value.
address is used for RTP voice streams. The starting port number is the port
number used by the first phone line, and the port numbers increment by two
for each line. You may type in a new value and then press Enter, or press
Enter without typing in a new value to retain the old value.
7
The IAD displays the RTP transport parameters. This is the same interface/
port/connection configured elsewhere in the IAD.
port/connection configured elsewhere in the IAD.
8
Enter the TOS byte of the SIP signaling packets [0-7]. You may enter a new
value or press Enter to retain the old value. The TOS values are prioritized
in the IP QoS menus.
value or press Enter to retain the old value. The TOS values are prioritized
in the IP QoS menus.
9
Enter the TOS byte of the RTP voice streams [0-7]. You may enter a new
value or press Enter to retain the old value. The TOS values are prioritized
in the IP QoS menus.
value or press Enter to retain the old value. The TOS values are prioritized
in the IP QoS menus.
Display SIP
Parameters
Type “I” on the SIP Management menu (Figure 4.46) to display the
configured SIP parameters.
configured SIP parameters.
CODEC Selection
Menu
Type “E” on the SIP Management menu (Figure 4.46) to select the CODEC
option you wish to use. The default is G.729a. The use of 726 and 729a are
mutually exclusive; the IAD will configure only one or the other.
option you wish to use. The default is G.729a. The use of 726 and 729a are
mutually exclusive; the IAD will configure only one or the other.
Display SIP Statistics
Type “S” on the SIP Management menu (Figure 4.46) to display the endpoint
(line) and connection statistics. If no calls are active, the IAD indicates
whether or not the endpoint is currently connected to its Notified Entity.
(line) and connection statistics. If no calls are active, the IAD indicates
whether or not the endpoint is currently connected to its Notified Entity.
If SIP configuration is not correct, the IAD displays a message warning you
that the configuration is invalid and intialization is incomplete.
that the configuration is invalid and intialization is incomplete.
Debug SIP
The commands displayed on the Debug SIP menu are reserved for Paradyne
network engineers.
network engineers.
Port Administration
Type “A” on the SIP Management menu (Figure 4.46) to display the Port
Administration Menu (Figure 4.47).
Administration Menu (Figure 4.47).
Figure 4.47
Port Administration Menu
Set Admin State for all Ports
Lets you enable or disable all ports on the IAD.