Zhone 2004 ユーザーガイド
T r o u b l e s h o o t i n g a n d D i a g n o s t i c s
7-1
C
H A P T E R
C
HAPTER
7
T
ROUBLESHOOTING
AND
D
IAGNOSTICS
This chapter describes procedures for troubleshooting and diagnosing
problems that may be associated with the IAD.
problems that may be associated with the IAD.
Diagnostics are destructive, and may result in loss of connection to network
or voice gateway. After running diagnostics, reset the IAD to return to normal
working order.
or voice gateway. After running diagnostics, reset the IAD to return to normal
working order.
NOTICE:
When the IAD prompts you for input, the current value is displayed in
parentheses. To conveniently accept the current value, just press Enter.
parentheses. To conveniently accept the current value, just press Enter.
Using the Diagnostics Menu
All diagnostic tasks are displayed and accessed on the Diagnostics menu,
which is displayed by typing “z” on the Main menu.
which is displayed by typing “z” on the Main menu.
Figure 7.1
Diagnostics Menu
You may sign on as Supervisor or Network Manager to perform diagnostics
tasks. Options that display in the Diagnostics menu are the same for both
security levels. Type the option and proceed to the appropriate section below.
tasks. Options that display in the Diagnostics menu are the same for both
security levels. Type the option and proceed to the appropriate section below.
POTS Diagnostics
A WAN uplink is not required to perform POTS testing. To perform POTS
diagnostics, type “P” on the Diagnostics Menu. The IAD loads and
configures the DSP software module, and displays the following menu:
diagnostics, type “P” on the Diagnostics Menu. The IAD loads and
configures the DSP software module, and displays the following menu: