Zhone 2004 ユーザーガイド

2 0 0 0 - A 2 - G B 2 2 - 0 0

After you unpack the IAD, find a suitable location to install the unit. Ideal 
locations include a computer equipment room or a telephone or wiring closet. 
You can locate the IAD on a table or shelf, or it may be wall-mounted. Install 
the IAD in a location that is generally protected and where it will be 
undisturbed. 

The IAD requires access to AC power (NEMA 15-3R). Make sure the IAD is 
located within 6 ft of an AC power outlet. Locate the nearest power outlet and 
plug in the supplied AC power adapter or AC power cord. If there is an 
uninterruptible power supply on premises, plug the AC power adapter or cord 
into that power source.

Ensure the power cord conveniently and safely reaches the rear panel of the 
IAD where the power plug or adapter jack is located.

When you install the IAD horizontally, make sure you maintain at least 2 
inches of horizontal distance from other IADs or other electronic equipment 
to ensure adequate ventilation and heat dissipation.

Make sure the telephone wiring, LAN, and WAN cables reach the IAD and 
can be dressed in a manner that is safe for the wiring, does not pull or create 
lateral stress on the connectors or ports on the rear of the IAD, and does not 
present a trip hazard to personnel working in the vicinity of the equipment. 
Do not connect any cables or wiring at this time.

The IAD is configured and managed from either the console or Ethernet port. 
A Telnet session is usually used to access the IAD via Ethernet. After you use 
a terminal emulator program via the console port (refer to DB-9 Console Port 
Pin Assignments on page B-5) for console port specifications) to set the IP 
address, you may continue to use a terminal emulator via the console port. 
The factory-set default IP address is 

 for the Ethernet port.