Zhone 2004 ユーザーガイド
C o n f i g u r a t i o n
4-7
Figure 4.6
ADSL Standards Menu.
2
Type the option corresponding to the ATM Standard. The IAD sets the
standard you select and displays the menu.
standard you select and displays the menu.
Enable/Disable ADSL
Debug Messages
Commands in this menu are reserved for Paradyne network engineers.
Configure
ATM PVCs
You may configure up to eight ATM PVCs on the IAD. Remember always to
reset the IAD to make PVCs active.
reset the IAD to make PVCs active.
1
Type “3” on the WAN configuration menu (Figure 4.2 or Figure 4.3). The
IAD displays the ATM PVC Configuration menu (Figure 4.7)
IAD displays the ATM PVC Configuration menu (Figure 4.7)
Figure 4.7
ATM PVC Configuration Menu
2
Type the option to perform a task. Each option is described below.
Add New PVC
To add a new PVC, follow the steps below.
1
On the ATM PVC Configuration menu, type “1”. The IAD prompts you to
enter the VPI.
enter the VPI.
2
Type a VPI value between 0 and 255 (default 0) and press Enter. The IAD
then prompts you for the VCI.
then prompts you for the VCI.
3
Type a VCI value between 32 and 65535 and press Enter. The IAD displays
the ATM Encapsulation Configuration menu as shown in Figure 4.8.
the ATM Encapsulation Configuration menu as shown in Figure 4.8.