Zhone 2004 ユーザーガイド
C o n f i g u r a t i o n
4-9
NOTICE:
Do not use “0” for Voice PVC because “0” will use all available
bandwidth, including CBR bandwidth that is not being used. Do not
oversubscribe available PCR. Use “0” for only one (1) PVC. Refer to
Peak Cell Rate (PCR) Considerations and Recommendations on
page C-1.
bandwidth, including CBR bandwidth that is not being used. Do not
oversubscribe available PCR. Use “0” for only one (1) PVC. Refer to
Peak Cell Rate (PCR) Considerations and Recommendations on
page C-1.
Modify Existing PVC
1
Type “2” on the ATM PVC Configuration menu (Figure 4.7). The IAD
displays the following port table, and prompts you to select the appropriate
port.
displays the following port table, and prompts you to select the appropriate
port.
2
Type the port number and press Enter.The IAD prompts you to enter the
VPI:
VPI:
3
Type a VPI value between 0 and 255 (default 0) and press Enter. The IAD
then prompts you to enter the VCI:
then prompts you to enter the VCI:
4
Type a VCI value between 32 and 65535 (the default is 38 for data and 39
for voice) and press Enter. The IAD displays the ATM Encapsulation
Configuration menu (Figure 4.8).
for voice) and press Enter. The IAD displays the ATM Encapsulation
Configuration menu (Figure 4.8).
Select the encapsulation you want to assign to this PVC in accordance with
the following paragraphs.
the following paragraphs.
AAL5 or AAL0
1
Type “1” on the ATM Encapsulation Configuration menu (Figure 4.8) to
select AAL5, or “2” to select AAL0 encapsulation. The IAD displays the
ATM Service Category Configuration menu (Figure 4.9).
select AAL5, or “2” to select AAL0 encapsulation. The IAD displays the
ATM Service Category Configuration menu (Figure 4.9).
2
Type “1” to select CBR for high priority data
− or −
Type “2” to select UBR for low priority data. The IAD displays the Peak
Cell Rate Configuration menu (Figure 4.10).
Type “2” to select UBR for low priority data. The IAD displays the Peak
Cell Rate Configuration menu (Figure 4.10).
3
Type the PCR value or press Enter to set the PCR to the maximum rate for
the current line speed. The IAD saves the configuration and displays the
ATM PVC Configuration menu.
the current line speed. The IAD saves the configuration and displays the
ATM PVC Configuration menu.