Zhone 2004 ユーザーガイド
4-20
2 0 0 0 - A 2 - G B 2 2 - 0 0
3
Continue with other configuration tasks, or press Escape to return to the
Main menu.
Main menu.
NOTICE:
For RIP to function correctly, you must enable RIP globally or locally
(by port) and set the RIP version. The order in which you perform each
procedure is irrelevant.
(by port) and set the RIP version. The order in which you perform each
procedure is irrelevant.
Configure RIP Version by Port
To configure RIP Version by Port, follow the steps below.
1
Type “V” on the Router Configuration menu (Figure 4.16) to select
Configure RIP Version by Port. If more than one WAN port is installed or
more than one PVC exists, the IAD displays the interfaces on this IAD
(sample shown in Figure 4.17).
Configure RIP Version by Port. If more than one WAN port is installed or
more than one PVC exists, the IAD displays the interfaces on this IAD
(sample shown in Figure 4.17).
2
Type the interface number to set. The IAD displays the port table for this
interface and prompts you to select a port:
interface and prompts you to select a port:
3
Type the port number to set and press Enter. The IAD displays the RIP
configuration and status of the slot and port you’re setting, and prompts you
to select a new version:
configuration and status of the slot and port you’re setting, and prompts you
to select a new version:
4
Type the option number of the version to set. Setting the RIP version for this
port is complete. The IAD saves the settings and displays the Router
Configuration menu (Figure 4.16). Repeat these steps for each remaining
port to set.
port is complete. The IAD saves the settings and displays the Router
Configuration menu (Figure 4.16). Repeat these steps for each remaining
port to set.
5
Continue with other configuration tasks, or press Escape to return to the
Main menu.
Main menu.
Configure RIP Poisoned Reverse by Port
To configure RIP Poisoned Reverse by port, follow the steps below.
1
Type “P” on the Router Configuration menu (Figure 4.16) to select
Configure RIP Poisoned Reverse by Port. The IAD displays the interfaces
on this IAD (sample shown in Figure 4.17)
Configure RIP Poisoned Reverse by Port. The IAD displays the interfaces
on this IAD (sample shown in Figure 4.17)
2
Type the number of the port to enable or disable. The IAD displays the RIP
status of this port and prompts you to enable or disable RIP Poisoned
Reverse for that slot and port.
status of this port and prompts you to enable or disable RIP Poisoned
Reverse for that slot and port.
3
Type “E” to enable RIP Poisoned Reverse, or type “D” to disable it. The
IAD saves the configuration, and displays the Router Configuration menu
(Figure 4.16). Repeat these steps for each port for which you want to enable
RIP poisoned reverse.
IAD saves the configuration, and displays the Router Configuration menu
(Figure 4.16). Repeat these steps for each port for which you want to enable
RIP poisoned reverse.
4
Continue with other configuration tasks, or press Escape to return to the
Main menu.
Main menu.