Zhone 2004 ユーザーガイド

C o n f i g u r a t i o n

To set the LAN IP broadcast destination address (where all broadcast IP 
packets received on the LAN ports will be redirected), follow the steps below.

On the Router Configuration menu (Figure 4.16), type “B”.

The IAD displays the current LAN IP broadcast destination address and 
prompts you to enter a new address.

Type the new IP address. The IAD saves the changes and displays the 
Router Configuration menu (Figure 4.16).

Continue with other configuration tasks, or press Escape to return to the 
Main menu.

To display the Route table and view information about statically configured 
routes and dynamically learned ones, type “D” on the Router Configuration 
menu (Figure 4.16).

The IAD displays each network address and related information:

Route Table parameters are described in the following table. 

This section describes how to configure the IAD as a bridge. A bridge is a 
device that connects and passes packets between two network segments that 
use the same communications protocol. A router generally improves overall 
efficiency for a complex network, but a bridge provides better speed and 
flexibility for the overall network.

Network Address

destination address

Netmask

IP subnet mask; number of bits reserved for the 
host ID

Gateway Address

IP address of packets sent to destination

Interface

IP address of outgoing interface

Metric

number of hops (routers) required to reach the 
specified gateway

Type

static | dynamic | RIP | local