Zhone sia2410r ユーザーガイド

 

Net To Net Technologies SIA2410R User Manual 

 

Net To Net Technologies                                                                                                     35 

As described above, setting the bridge mode without deleting the 
routing mode from the interface will trigger a setup of "Routing and 
Bridging Mode". To set a mode to "Bridging-Only Mode", the routing 
mode must be deleted. 
 

Command 

interface <ifname> bridge enable 

ip routing disable <ifname> 

Confirmation of 
Setup 

(conf)# sh int 

: Confirm "Bridging-Only Mode". 

 

Note: To operate as a bridge, you must configure "Bridging-Only Mode" to all 

interfaces(LAN and WAN). 

 
 
 

In order to forward bridged packets to the right network destination, 
the SIA2410R uses a bridge table that associates end nodes with 
particular connections. It builds this table dynamically, in a process 
called transparent bridging.  The following command shows the 
bridge map: 
 

Command